Ga1110 eze revolver cylinder loader
![Complete single collection rar](https://kumkoniak.com/89.jpg)
I have a "worry" about putting a bend or break to the ROA base pin through extended use, and since there are no more of these parts available I thought that this is good insurance.
![ga1110 eze revolver cylinder loader ga1110 eze revolver cylinder loader](https://i.pinimg.com/originals/63/c8/aa/63c8aacaee10841c2b0bbaa26a485d96.jpg)
Mine were supplied with stubby brass arbor(s) for the cylinder arbor stud, and no spring like the one in the previous photo. It came through a little crude, but with some de-burring with a couple of different profile files, all is well. I bought my "Powder Inc." style of press on eBay for $58.00 delivered.
#Ga1110 eze revolver cylinder loader portable#
It's relatively small and portable which makes toting it to the range very convenient. There's a rubber disk fitted flush within the base located under the cylinder plate to provide a cushioned backing for when using the wad cutting attachment to not damage the sharpened edge.Ħ. Optional wad cutting attachments for cutting wads & over-powder cards.ĥ.
![ga1110 eze revolver cylinder loader ga1110 eze revolver cylinder loader](http://www.sdweirun.com/uFile/36260/product/2016427145742132.jpg)
An indexed rotating cylinder plate with different pins and wells to accommodate seating different size cylinders.Ĥ. An adjustable threaded ram with brass tip to control the depth of ramming.ģ. A rammer with toggle linkage to make ramming easier.Ģ. It's so helpful that I can't imagine not using it.ġ. The chambers are also easier to access for loading powder, wads, grease etc.by simply rotating the cylinder plate out from under the ram. I usually load 2 Remington cylinders at a time, and this loader makes loading them a lot of fun, and much faster and easier. I use the Triple P Loader that was available on THR in 2009 by pre-ordering it from 6Gun4Fun, but it's no longer made.
![Complete single collection rar](https://kumkoniak.com/89.jpg)